Talk to a performance expert
mon-thurs 9-5 cst
There are two style rocker arms: square tip and round tip. The square style becomes more prominent due to the stabilization over the round style rockers. It is not uncommon for the rocker arms to not be a true 1:1 ratio some times they can be 1:1.05, 1:1.1, etc. This is important because it will change the running lift if it's checking for legality. To fix this problem most rules allow grinding to make it 1:1 ratio or to compliment your cam for the maximum allowed running lift.
These stainless steel pushrods are the OEM Replacement for 196cc 6.5hp GX200 Clones including the Tillotson 196R/RS, Ducar 196, and Box Stock 196. These also fit the Predator 212 Non-Hemi Cylinder Heads.
AKRA 2020 Rules for Rocker Arms
Factory stock rocker arms 1:1 ratio and pushrods only. The minimum overall length of rocker arm 2.145”. Minimum thickness of the upper valve stem end of rocker arm .030”. The surface finish of the contact area of the rocker arm to valve only, non-tech, to adjust for proper running lift. Square tip rockers allowed.
NKA 2020 Rules for Rocker Arms
220.127.116.11: Rocker Arms:
18.104.22.168.1: 1:1 ratio rocker arms only.
22.214.171.124.2: Rocker arms must be steel and are subject to magnetic tests.
126.96.36.199.3: Rocker arms are allowed to be ground on valve stem location only, or on bottom of the rocker arm to allow the running lift to be compliant. Grinding on the sides of the rocker arm is prohibited. No minimum thickness checks.