1. Home
  2. Engines
  3. Tillotson 196R Clone Engine
  4. Tillotson 196R Rotating Assembly
  5. 6267 ARC Honda/Clone -.020 Shoter Billet Rod
6267 ARC Honda/Clone -.020 Shoter Billet Rod
6270 Honda/Clone F200 Stock Length Rod
Write a Review

6267 ARC Honda/Clone -.020 Shoter Billet Rod

Part Number: 6267
Your Price: $64.95
Availability: Out of Stock.

Description

ARC -.020" short length billet rod for the GX200 & GX160 or the BSP196cc(Clone). 

Machined from domestic 7075-T651 aircraft-grade aluminum. 3.283" center-to-center for a 1.180-rod journal and .709" wrist pin. Uses ARC's custom manufactured bearing inserts and ARP rod bolts manufactured specifically for ARC. ARC has the only forced oiling scoop dipper rods available for these engines providing superior lubrication at the bearing journal.

Rod bolt torque: 170 in/lbs lubricated

Installation Instructions:

To install your ARC rod you will need a 12 point 1/4" socket and a QUALITY inch-pound torque wrench. You will need an outside micrometer, dial bore gauge or plasti-gauge, and oil.

Measure the crankpin diameter with the outside mic, it should measure 1.180" +/-.0005". Measure in several spots to ensure roundness. If out of round more than .0005" it probably should be replaced. The crankpin finish should be smooth to the touch.

When disassembling the rod notice on the side of the rod with the part number there are two dots next to the separation point of the beam and cap. These dots help to re-orientate the cap and beam when assembled. The side of the rod with the part number engraved will always face the side cover side.

Make sure the bearing and rod serrations are clean and install the bearings. Lubricate the rod bolt threads and hand tightens the bolts. Using the torque wrench tighten the bolts to 60" lbs. Alternate each side to increase the torque by 20" lbs at a time until you reach 150" lbs. Then loosen the bolts and repeat the torque process. this helps seat the rod bearing especially on a new rod. Measure the bore with your dial bore gauge opposite the parting lines. If using plasti-gauge you will have to install the rod on the crank and use it in accordance with the plasti-gauge instructions.

The rod bore should measure 1.183 +/.0005". With plasti-gauge you are looking for about .003" clearance. From .0025-.0035" clearance is acceptable. Anything outside that dimension please call 800-521-3560 for a recommendation.

Once clearance is set apply oil to the rod, crank, and wrist pin and install this time torque to 170" lbs.

Improperly torquing rod bolts is one of the most common causes of rod failure.

Refer to instructions shipped with all rods and the video below for more detailed instructions. 

Related Items

6270 Honda/Clone F200 Stock Length Rod
$64.95
Out of Stock.

Recently Viewed Items