1. Home
  2. Carburetors
  3. Intimidator Series
  4. X360 Intimidator
  5. EC X360A-10 Intimidator Carburetor for GX200/Clone/Predator Methanol Carb Only
EC X360A-10 Intimidator Carburetor for GX200/Clone/Predator Methanol Carb Only
X360A-10 EC Intimidator Carburetor for GX200/Clone/Predator Alky Carb Only
Write a Review

EC X360A-10 Intimidator Carburetor for GX200/Clone/Predator Methanol Carb Only

Part Number: X360A-10
Your Price: $325.00
Availability: In Stock.

Send to:

*We'll ask for shipping info at checkout

Description

X360A-10 EC Intimidator Carburetor for GX200/Clone/Predator Alky Carb Only

The Intimidator Carburetor is the brainchild of EC Birt and Carroll Ford to design a better carburetor from scratch that will outperform any manufacturer's carburetor but be affordable. The X360 is intended to be a one-piece casted body. We innovated an infinite radius venturi to balance airflow and fuel signal. Then the body is polished to a high-shine finish. We then reduce flow restriction with our signature three-piece throttle shaft. Custom design and casted fuel pump plate for higher fuel flow. Custom Billet adjustment needles and our high flow red fuel inlet cap. All of these parts are hand-assembled by our master carburetor technicians.


While all things are possible, the X360 is a far superior carburetor from start to finish. Other manufacturers and carburetor builders fall short in their initial design and intent for other engine applications. Our Intimidator Carburetors replace our 3+3 Twilight Zone Custom-built Tillotson carburetor($600-1000+) with a blank body ready for any fuel circuit and modifications to fit any engine. These carburetors are built with custom plate stacks, billet needles, and our EC signature three-piece throttle shaft.


Carburetor Size:

Bore 1.00" (25.4mm)

Venturi .940"(23.876mm)


Fuel: Methanol(alcohol) pure methanol only; DO NOT BUY METHANOL WITH TOP LUBE OR ADD TOP LUBE.


Caution: WILL NOT WORK WITH ETHANOL E-85 or E-91 or any other type of ethanol.


Carburetor Tuning:

Hi Side Needle Initial setting: 1 turn out

Low Side Needle Initial Setting: 2-1/2 turns out


Caution: Use only the Walbro FPC-1 Fuel pump!

Fuel pumps we do not support with our carburetors:


B&S fuel Pump


Mikuni, and Mikuni knock offs


Plastic knock off of the Walbro WIP fuel pump (square pump)


No electric fuel pumps.


If you have a fuel pump, you would instead use, please call us to advise you.

Related Items

Recently Viewed Items