Talk to a performance expert
mon-thurs 9-5 cst
Fulcrum Arm Height is the measurement between the carburetor gasket surface to the tip of the fulcrum arm.
Ð²€Ñž Factory Fulcrum Arm Height is typically set at .085".
Ð²€Ñž For most gas carburetors, we set the fulcrum at .075" using our 705 EC Tillotson Gas Fulcrum Arm Gauge
Ð²€Ñž For most methanol carburetors, we set the fulcrum at .065" using our 704 EC Tillotson Gas Fulcrum Arm Gauge
The 155A-23 OE Tillotson Inlet Control Lever/Fulcrum Arm is "uncaptured." Tillotson Uncaptured Fulcrum arm differs from captured fulcrum arm where the tab rests on top of the inlet needle rather than "capturing" the needle.