The EC 1.2 Billet Aluminum Ratio Rockers are designed for Non-Hemi Style Honda, Clone, Tillotson, and Predator Cylinder Heads.
The EC Rev Rockers have been redesigned and updated to include needle bearings and a larger roller tip.
Needle BearingsāCustomers concerned with reducing friction and wear highly requested needle bearings. With a bearing-less rocker, customers could assemble the rockers without using assembly or any lubricant, which causes the rocker arm to seize immediately or damage the bushing or rocker arm. Using needle bearings will reduce the chance of damaging the rocker's arm. However, this is no excuse for not properly lubricating the valve train. When installing the rocker's arms, use Maxima Racing Oil Assembly Lube.
The new rocker arms are a bit beefer to fit the roller rockers, but we wanted to keep the weight down as much as possible. The rocker's arm is more vital than before, and the highest has a needle bearing on the market. Keeping the valve train weight to a minimum helps stabilize the valve train, especially regarding aggressive cams and high rpms.
Roller Tip - The roller tip was another customer feature that requested a lash cap. Most applications do not require lash caps. Lash caps are used with Titanium valves because titanium will gall. Stainless steel valves have more robust, hardened tips. Along with our relatively low spring pressure compared to motorcycle and automotive engines, you don't see excessive wear with good lubrication. The other benefit is that more rocker arms will be provided for retainer clearance. The small engine market is pushing for more significant lift and aggressive setups. A slightly larger diameter roller will help ensure our rocker arms are used at the highest level of competition.
The rocker's arms are mounted on a standard shaft or trunnion that keeps them stable above the valve and pushrods. The roller tips reduce friction and wear on the valve tips. The shaft mounting also helps reduce distortion and deflection, improving valve movement truer to the camshaft profile, resulting in better performance.
The Rockers have a 1.2:1 ratio, and rocker arm geometry plays a significant role in valve movement. Since the rocker arm should increase the valve lift, it will increase valve acceleration and duration, especially from .150" and higher. Performance will increase, but your spring pressure may need to improve, too. Some cam cards will have a recommended seat pressure for the cam. These recommendations are often based on stock-size valves, which weigh less than most oversized valves, and stock rocker arms, which weigh less than aftermarket rocker arms. Increasing weight, lift, and valve acceleration will require more spring pressure.
Rev Rocker Features:
- Rocker Arms are made from aircraft billet aluminum
- Harden Roller Tip with an oversized pressed-in axle with clip for increased strength
- Larger Diameter Roller Tip for extra clearance
- Titanium Lash Adjuster Nuts
- Increased material on the Rocker Arm Tip adds rigidity and strength.
- Needle Bearing for the main shaft for improved durability and performance
- The main shaft includes snapping rings to secure the rockers, which are protected by brass washers between the rockers and on the outside of them.
We were able to increase the durability and performance with minimal increase in price; the new Rev Rockers are the less expensive rocker arms on the market that use a needle bearing.